Rust blooming under a paint film, a plated fastener that pits within months, a coated bracket that blisters near the coast: corrosion is one of the costliest ways a product can fail, and Chennai’s humid, coastal air makes it a real concern. Dependable salt spray testing in Chennai exposes coatings and finishes to a controlled salt fog, so weak points show up in days instead of years.
At Kiyo R&D Lab, we run corrosion exposure tests and report the results against the applicable standard. Our team combines NABL-aligned methods with expert interpretation, so your decisions rest on evidence, not guesswork.

Your guide to corrosion testing at Kiyo R&D Lab
A salt spray chamber surrounds test samples with a warm, fine mist of salt solution, which speeds up corrosion. Good salt spray testing in Chennai shows how well a coating, plating or finish protects the metal underneath, and whether a batch matches an approved reference. ASTM B117 testing is the most widely requested method, and it defines how the chamber is operated rather than setting a pass or fail limit.
The table below summarises the typical operating conditions. Exact limits follow the standard edition and your customer specification.
| Parameter | Typical ASTM B117 Condition |
|---|---|
| Salt solution | 5% sodium chloride, neutral pH (about 6.5 to 7.2) |
| Chamber temperature | About 35 °C |
| Fog collection rate | About 1 to 2 mL per hour per 80 cm² |
| Specimen position | Held at an angle, about 15 to 30° from vertical |
| Duration | Set by your product specification (for example 24 to 1000+ hours) |
| Evaluation | Visual rating of rust, blistering and creep from a scribe |
Because the duration and the acceptance limits come from your specification, the value of salt spray testing in Chennai lies in running the chamber consistently and rating the samples fairly.
Following these steps keeps salt spray testing in Chennai repeatable from one batch to the next. For broader material work, see our plastic testing laboratory page.

From coating selection to batch checks, good decisions start with good data. As a trusted partner for salt spray testing in Chennai, Kiyo R&D Lab delivers ASTM B117 testing and related material tests under one roof, backed by ASTM/ISO methods and NABL-accredited reporting where applicable.
Tell us your sample, finish and required duration. Our team will plan the right run and get you defensible results from salt spray testing in Chennai you can rely on.
Call: 90420 86986 | 90876 86986
Web: www.kiyorndlab.com
Our salt spray testing in Chennai follows ASTM B117, and ISO 9227 where your specification calls for it. Accredited reporting is available for methods within our NABL scope; we confirm the exact status for your test before you commit.
Kiyo R&D Lab runs corrosion exposure tests and reports the results against the standard you name. Send your sample, finish type, test duration and specification, and we will confirm the method and timeline.
Both expose samples to a salt fog, but ISO 9227 covers several variants, including neutral, acetic acid and copper-accelerated tests, and differs in some operating details. Use the one named in your specification.
No. The test is accelerated and comparative, so it is best used to rank coatings and monitor batch consistency, not to promise an exact lifetime. A good report from salt spray testing in Chennai should state the method, duration and rating clearly.
Send several identical pieces so a retest is possible. The test runs for the hours your specification sets, which can be days or weeks, and we confirm the timeline after reviewing your samples.